Bendix/King KG-102A Directional Gyro

This remote-mounted unit integrates a spinning-mass directional gyroscope with an internal solid-state power supply. It processes magnetic flux signals from a remote KMT-112 flux valve to output stabilized magnetic heading telemetry to cockpit Horizontal Situation Indicators and autopilot flight computers.  

Description

This unit has been bench tested by an FAA certified repair station and it comes with an 8130 single release dated 9/23/2026.

Key Technical Capabilities

  • Gyro-Stabilized Heading Processing. Combines short-term gyroscopic stability with long-term magnetic north slaving from a remote KMT-112 azimuth transmitter to maintain a maximum free-gyro drift rate of 1 degree per minute.
  • Integrated System Power Supply. Generates regulated ±15 VDC and +5 VDC reference voltages to power the KI-525A HSI and KA-51B slaving accessory, alongside a 7.2 VRMS (400 Hz) primary excitation signal for the KMT-112 flux detector.
  • Auxiliary 26 VAC 400 Hz Output. Supplies up to 5 VA of 26 VAC, 400 Hz reference power, eliminating the need for a dedicated external static inverter in light-load installations.
  • Heading Loop & Slaving Drive. Outputs direct motor drive signals to position the compass card inside the KI-525A HSI and drives the slaving error meter on the KA-51B controller, providing a discrete ground valid signal on pin a.
  • Dual-Voltage Input Architecture. Accepts either 14 VDC or 28 VDC aircraft bus power depending on installation strapping, operating across a -55°C to +55°C environmental range.

Additional information

Part Number

060-0015-00

Serial Number

52779

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.